5073 Polyaspartic Fast Drying Clear Concrete Floor Primer/Sealer
Our high solids 5073 Polyaspartic coating has been formulated to be one of the easiest polyaspartic’s to apply by roller and brush, making it the ideal topcoat to use over a variety of concrete floor coatings. We have formulated extra pot life into the 5073 Polyaspartic system. We recently released a retarder that will extend the pot life to offer even more pot life when needed.
Number One Choice for Over Garage, Commercial, and Industrial Floors
The 5073 Polyaspartic Fast Drying Clear Primer/Sealer is the most popular clear topcoat that we have. It is widely used over our Roll on Rock® Epoxy Flake Flooring System that is designed to be used over concrete floors. It is also widely used as a protective topcoat over bare concrete floors, stained concrete floors, commercial and industrial concrete floors, and decorative concrete floors. The water clear high-gloss and high-build film of the 5073 Polyaspartic provides a beautiful topcoat finish that will look great for years. The chemical backbone of the 5073 Polyaspartic coating is designed to be extremely scratch resistant while also having great chemical resistant properties. The scratch resistance built into the clear topcoat will allow it to maintain its gloss for a longer time when compared to other concrete floor coating products. The 5073 Polyaspartic is resistant to deterioration by ultra violet rays emitted by sunlight or high intensity lighting systems.
Easily Applied to Decorative Concrete Floors
We have reduced the 5073 Polyaspartic viscosity down to levels comparable to a medium solids CRU (chemical resistant urethane). The benefits of this arethat the 5073 Polyaspartic Fast Drying Clear Primer/Sealer is easier to install, has more pot life, cures to a hard film faster (dries in two to three hours) and is suitable for exterior exposure without yellowing. The only drawback is that 5073 Polyaspartic is considered combustible, and its use should be restricted to well ventilated areas.
Fast Turn Around Time
Use 5073 Polyaspartic Fast Drying Clear Primer/Sealer when you need a faster turnaround time so you can get that coated concrete floor back in service fast. If you are sealing decorative concrete floors then you should look at using the 5205 Polyurea Ultra-Fast Drying Clear Primer/Sealer (it dries in one hour) and the 5073 Polyaspartic as the topcoat. This combination provides a fantastic high build looking finish that can be used outside or inside. Use it over stained concrete, decorative microtoppings and stamped concrete.
Features and Advantages:
Anywhere else that could benefit from a polyurea coating