Solid Color Waterborne Concrete Epoxy Flooring
4010 Waterborne Pigmented Epoxy Floor Coating is a pigmented epoxy sealer coating designed for use over concrete floors. The 4010 Epoxy utilizes an epoxy crosslinking technology that allows it to breathe out moisture emissions found on high MVE (moisture vapor emissions) concrete floor slabs. The 4010 Epoxy is used as a flake receiver coat as well as a final coat for monolithic or solid color floors. Due to its waterborne technology, the Epoxy is very user friendly and can be used in most areas. Our 4010 Epoxy is ideal to use over residential garage floors, light industrial retail concrete slabs, and commercial floors where a high-gloss solid color, hot tire resistant concrete epoxy is desired. The 4010 Waterborne Pigmented Epoxy Floor Coating will provide the look and much of the performance typically found in 100% solids concrete floor epoxy coating system while also remaining a breathable low odor epoxy flooring.
Pros and Cons of Broadcasting Flake into our Pigmented Waterborne Concrete Flooring Epoxy
When broadcasting flake into the 4010 Epoxy it must be done quickly since it is a faster drying epoxy which has a shorter pot life than our 4195 Direct-to-Concrete Pigmented Epoxy Floor Coating. One of the advantages of the 4010 Epoxy is that the flakes will typically lay flatter which results in less elbow grease to remove loose flakes and a flatter surface that requires a little less clear topcoat. One of the disadvantages is that it does not wick into the concrete floor as deeply as the 4195 Epoxy does, so you will have a higher chance of failure when exposed to higher MVE (moisture vapor emissions).
Features & Advantages
Where Used:
|
4010 Pigmented
|
||||
|
Physical Properties
|
Chemical Resistance
|
|||
|
Tests Done at 70 Degrees
|
Acetone | Faint Spotting | ||
|
Fahrenheit with 1/2 Pint Mass
|
||||
| Pot Life | 60 minutes | Xylene | No Effect | |
| Gel Time (Hours) | 3 Hours | 10% HCL | Spotting | |
| Through Dry (Hours) | 12 | Ammonia | No Effect | |
| VOC g/L | 49 g/l | Degreaser | No Effect | |
| Percent Solids | 63/Wt. 52/Vol. | Liquid Plummer | No Effect | |
| Flammable | No | Vinegar | Faint Spotting | |
| Odor | Low | Clorox | Faint Spotting | |
| Pencil Hardness | H-2H | Windex | No Effect | |
| UV Resistance | Poor | Motor Oil | No Effect | |
| Non Yellowing | Poor | Gasoline | No Effect | |
| Abrasion Resistance | Good | Hot Tire | No Effect | |
This item will not be shipped! This item is available for customers that are local to Southern California and can pick up your order located at our warehouse in La Mirada, California
Important!: Make sure that if you order this product, you DO NOT have products from other categories in your cart during checkout.
Note: Our full-time graphic designer has created the color charts for epoxy floors below to give as close a representation of our products' appearance as possible. Your computer's display settings may vary the appearance of the color samples in our color charts for epoxy floors.
